I cannot say enough wonderful things about ‘My Favorite Pool Builder’. Make sure it’s enabled by going through the menu like we’ve been doing, check your speed instead of flow. So far thermal mode set from the factory, you just want to check to make sure it’s correct and that it’s on. Priming I just lower the speed that it primes at so it’s not revving up so high. If it was in schedule it would switch to the timed schedule. Then after that, it would shut off if it’s not in schedule. It’s used to clean the pool when you’re out of schedule for example you had a party in the middle of the night and then whenever you’re done and you want to start the pool cleaning you would hit quick clean and run through the 10 hour program. Quick clean set up is just like everything else in the system you have to select it, set your speed set your time, and normally set it for 10 hours at the high speed setting of the pump in 2500 2350. I normally hit the stop-start and turn the pump off, the danger of that though is its if you forget to turn the pump back on now it’s not going to run at schedule. So this allows the technician to clean the pool filter. Timeout used in the feature section to make it where you can actually shut the pump down for predetermined time say 15 minutes half hour or hour.
Thermal Motors and features and we’re going to go through features kind of quick because it’s basically works the same way as everything else, just toggling up and down and making the changes that you need to make, an end of each individual section Keep in mind this pool is just being set up to run temporarily for now just for this demonstration, also the water is in the 40-degree mark where right now it doesn’t really need to run as much. We are setting our shut down time for 11:01 a.m. the overlap will allow whichever pump speed is higher speed to run for that one minute just to avoid the pump trying to shut down and restart quickly. You would go through the schedule, down to speed, change your speed if you need to in the speed section, select that then you get to the start time with your starting at 7 a.m. The only thing I want to show you is that this one thing about time overlap. You would do everything the same way as we did in five. Program six is the same as five also 7 at 8. on this pump and we set it to run from 6 a.m. once you set your shut off time you hit save back get to the main menu by hitting back, turn the power off, turn it back on. I think your problem is that you are trying to separate your cleaner operation from your pool operation.We’re setting this one for 7:01 a.m.
#Pentair easy touch timer free
If I turn on the fill line and let it run for 30 minutes and then hit the reset button, the egg-timer would reset to the programmed one hour and not the default of 12 hours.įeel free to change your run time if you wish, but I doubt it will have any effect on the egg-timer operation. If an egg-timer is in the middle of running, I would assume it would reset to the default or whatever it was programmed to do.Īs an example. I don't believe that it will change any of the egg-timers that have been programmed to something other than the default. The reset is like turning all the power off and the back on.
I just select the line and change it to don't stop. Egg-timers, that are not set at the default value of 12 hours, count as a program or schedule.
0 kommentar(er)
